湖南ABB代理商供应 伺服电机 3HAC029924-003三轴电机

伺服电机维修故障范围：

维修故障：

•   磁铁爆钢、磁铁脱落、卡死转不动、

•   编码器磨损、码盘/玻璃盘磨损破裂、

•   电机发热发烫、电机进水、

•   电机运转异常、

•   高速运转响声、噪音大，

•   刹车失灵、刹车片磨损、

•   低速正常高速偏差、高速正常低速偏差、

•   启动报警、启动跳闸、

•   过载、过压、过流、

•   不能启动、启动无力、运行抖动、

•     失磁、跑位、走偏差、

•   输出不平衡、

•   编码器报警、编码器损坏、

•   位置不准、

•   一通电就报警、一通电就跳闸、

•   驱动器伺服器报警代码、

•   烧线圈绕组、

•   航空插头损坏、

•   原点位置不对，编码器调试/调零位、

•   更换轴承、轴承槽磨损、

•   转子断裂，轴断裂、

•   齿轮槽磨损等
  
  如果你有关于机器人任何配件的维修咨询，请即时与湖南驰开智能机器人有限公司联系吧。

Scope of servo motor maintenance faults:
Repair fault:
Magnet explodes, magnet falls off, gets stuck and cannot rotate
Encoder wear, code disc/glass disc wear and tear
Motor heating and scalding, motor water ingress
Abnormal motor operation
High speed operation with loud noise,
Brake failure, brake pad wear
Low speed normal high speed deviation, high speed normal low speed deviation
Start alarm, start tripping
Overload, overvoltage, overcurrent
Unable to start, weak start, shaking operation
Loss of excitation, displacement, deviation
Output imbalance
Encoder alarm, encoder damage
Inaccurate position
Alarm upon power on, trip upon power on
Drive server alarm codes
Burn coil winding
Damaged aviation plug
The origin position is incorrect, encoder debugging/zero adjustment
Replace bearings, wear bearing grooves
The rotor is broken, the shaft is broken
Gear groove wear, etc
If you have any maintenance inquiries about any parts of the robot, please contact Hunan Chikai Intelligent Robot Co., Ltd. immediately.